| 1. | Variance optimum value 方差最优值 |
| 2. | When the current exceeds the optimum value , the microwave mode changes , the output power decreases obviously , and the frequency spectrum is bad 当电流较大时,微波的模式会发生改变,输出功率显著下降,微波频率特性变得很差。 |
| 3. | The method is proved the right through similar analysis . which has important reference value as realized the optimum value of process scheme 仿真分析表明,该方法思路正确,方法可行,实现简单,对实现工艺方案的优化有重要的参考价值。 |
| 4. | The optimum dosing amount of coagulant which make the minimum resistance is in conformity with the optimum value which remove maximum dissolved organic matter in water studied 使膜过滤阻力最小的最佳混凝剂投加量与去除水中溶解性有机物效果最佳的投加量一致。 |
| 5. | With the increase of the polymerization temperature from 40 to 80 , the optimum values of n ( fe ) / n ( zr ) in these catalytic systems were shifted to some degree 当聚合温度从40升高到80时,几种复配体系催化乙烯聚合出现共单体效应的最佳配比n ( fe ) n ( zr )发生前移。 |
| 6. | The analysis of variance for the grey relational grade was implemented , and the optimum value of multi - objectives was obtained , so that the optimum combination of the factors was confirmed 对目标序列的灰色关联度进行方差分析,得到目标函数的最优解,从而获得最佳参数。 |
| 7. | There was an optimum value for the the moo3 of the perform . when the initial sic particles with small size were added into the performs , the properties of the infiltrated were improved 实验表明,材料的性能并非随坯体中moo _ 3含量的增加而增加,坯体中moo _ 3含量存有一最佳值。 |
| 8. | Based on the papers [ 1 ] , [ 2 ] , we construct the general location value and general elementary dependent function , which optimum value is at the midpoint , and get some properties 在文[ 1 ] 、文[ 2 ]基础上,提出一般位值的概念并构造在中点取得最大值的一般初等关联函数,得到若干性质。 |
| 9. | The effects of the beam parameters on the focusing are also discussed , and it is found that some of the parameters have optimum values which result in the strongest focusing of the probe beam 进一步分析了光束初始参数对信号光聚焦过程的影响,发现选择最佳参数值可提高光束的聚焦效率。 |
| 10. | The rate equations of theb3 + doped crystal laser in cw operation were solved . we analyzed several factorshich influenced the laser output and obtained the optimum value by calculation 建立了掺yb ~ ( 3 + )晶体激光器的速率方程,对影响连续激光器输出功率的因素进行了分析,得到了各种优化值。 |